Filtrete 4US-MAXS-S01 Installation Guide download pdf (Page 4)

HOT

COLD

(Fig. 6)

(Fig. 8)

(Fig. 9)

(Fig. 10)

(Fig. 11)

(Fig. 7)

MOUNTING THE FILTER

HEAD ASSEMBLY:

You will need: Phillips screwdriver, drill, pencil,

safety glasses, lter, head assembly (B),

#2 mounting screws (I)

1. Choose a location to mount lter head assembly

(B). Keep in mind: Filter head should be in

a location that offers easy access for changing

lters. Leave 2 ½" of clearance below the installed

lter cartridge. (See Fig. 6)

2. Using the bracket on the head (B) as a guide,

mark the location of the two screw holes on the

wall with a pencil. (Fig. 7)

3. Fasten the head to the wall using a Phillips

screwdriver and the two mounting screws

included (L) (Fig. 8). (If preferred, use a drill

with a 1/8" size drill bit to make pilot holes

for the screws.)

4. Check to assure mounting bracket is

rmly installed.

(Fig. 2) (Fig. 3)

(Fig. 4)

(Fig. 5)

INSTALL FAUCET:

You will need: faucet with attached tubing, nut (C), faucet mounting shim (F), faucet gasket (G),faucet spout (H).

1. Place the faucet gasket (G) on the faucet and insert faucet tubing, shaft and nut (C) into pre-existing soap dispenser or sprayer

opening in sink. (If no opening exists, or installation is desired elsewhere, a 1 ¼" opening must be made.) (Fig. 2)

2. Install faucet mounting shim (F), onto faucet shaft (Fig. 3) and hand tighten nut. (Fig. 4)

3. Insert spout (H) into faucet body (C). Hand tighten faucet spout nut. (Fig. 5)

Faucet Opening Insert Shim

Tighten Nut Spout Insert

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Filtrete 4US-MAXS-S01 Installation Guide Page 4